Ultrapole: The Universal Antenna Mount
waveform.com
Questions? Suggestions? Need help? Call 1-800-761-3041, or email help@waveform.com
Run into any issues or have any suggestions? Call 1-800-761-3041, or email help@waveform.com
to get connected with our dedicated Waveform Signal Specialists. We’d love to hear from you.
Where to Install the Universal Antenna Mount
Here are some suggestions on where to install the Universal Antenna
Mount:
1 Rooftop. When installing on a roof, make sure to properly seal any penetrations
made by screws. Consider using pitch pads, roong sealant/caulking/cement, or
other weather proong materials.
2 Wall / Siding / Fascia. Installing on the side of a building? Make sure the
footpad(s) are secured against a sturdy material. Damaged, rotted, or weakened
material may cause issues later on.
3 Pole / Railing. If your roof or siding isn’t suitable, the Universal Antenna Mount
can be installed against a pole or railing. In such cases, hose-clamps or U-bolts are
recommended.
4 And many more! Don’t let an instruction manual be the boss of you. You’re
Leonardo da Vinci, and installing this mount is your Mona Lisa. It includes mounting
equipment to enable its installation at a variety of locations! It’s called the Universal
Antenna Mount for a reason.
Assembling the Base Kit
Use the provided Size-8/10mm Wrench to assemble the Base kit. Follow the steps listed below:
1. Install Footpad
against a surface.
2. Attach J-Pole with
pivot Bolt.
3. Install adjustment
Bolt and adjust J-Pole
5. Secure each Bolt
with a Washer and Nut.
4. (Optional) Install lock
Bolt.
Base Kit
F
4
x
G
5
x
E
4
x
CA
B
B
5
x
D
• 1x J-Pole
• 1x Footpad
• 4x Bolts, Plastic Washers,
and Flange Nuts*
• 5x Expansion Bolts*
• 5x Wood Screws and
Anchors*
• 1x Size-8/10mm Wrench
• 4x Zip and Velcro Ties
B
D
E
F
G
A
C
*Includes 1x spare
Extension Kit
A
F
2
x
C
5
x
D
2
x
B
G
• 1x Extension Pole
• 2x Brace Arms
• 2x Bolts, Plastic Washers,
and Flange Nuts*
• 5x Expansion Bolts*
• 5x Wood Screws and
Anchors*
• 1x Size-8/10mm Wrench
• 1x Size-4mm Allen
Wrench
A
B
C
D
E
F
G
*Includes 1x spare
5
x
E
To assemble the mount, use the Bolts, Plastic
Washers, and Flange Nuts.
To install the mount against a surface, use the
Wood Screws, Anchors, and Expansion Bolts.
• For hard materials (e.g. concrete, brick mortar):
- Use the Wood Screws & Anchors.
- The Anchors require a pre-drilled 8mm hole.
• For semi-soft materials (e.g. wood):
- Use the Wood Screws.
• For soft materials, (e.g. plaster, drywall):
- Use the Expansion Bolts.
- The Expansion Bolts require a pre-drilled
12mm hole and PH2 Phillips-head screwdriver
(not included).
Tip: Prior to drilling, place the footpad against the
intended mounting surface and mark the location of
each hole with a pencil or marker.
Screw & Bolt Guide
To Next Page
Need help?
General