English
Advice on location, care and safety
• Connect the audio input to the line-out, non amplified output. Avoid connection to the
speaker-out jack of your sound source. The amplified signal from the speaker-out may cause
unnecessary distortion and may damage the speaker-circuit.
• To connect your sound-system with power supply system, please make sure to have a mains
socket close to your sound-system.
• Before mains connections, check your mains power system to be appropriate to the
TWO NEO/PRO. The mains voltage (230V or 115V) of your power system you can set by the
VOLTAGE SELECTOR of your TWO NEO/PRO (beside the POWER switch) and you can verify
the actual setting of the mains voltage easily. Attention: if the mains voltage is set wrong, the
device may become defective! Always set the correct mains voltage to avoid defects!
• If the sound-system is not in use for a longer period of time, be sure that your system is
disconnected from mains power.
• Do not use alcohol, benzene, thinner or acids to clean the cabinet.
• Do not place your sound-system near radiators, airconditioning or radio-controlled systems.
• Avoid leaving the sound-system in permanent strain such as direct sunlight, extreme moist or
dryness, exceptional cold or heat, mechanical vibrations or shock.
• Do not open the cabinet, contact qualified personnel only.
• For service staff: Never open cabinet, when speaker system is connected to 110-240 V
AC power supply system.
• CAUTION!! Power ON / STANDBY switch does not separate mains power!
• Deliberate harm to the equipment is not covered by the guarantee.
• Please contact your dealer in case of technical problems.
14
To Next Page
Loading...
