Wavemaster TWO NEO - Audio Configurations; Connection to Analogue Audio Sources; Connection to Digital Audio Sources

English
• AUDIO SIGNAL SENSING: if the input signal is very low or off for more than 10 minutes, the
audio signal sensing automatically switches to STANDBY. Once there is an audio signal, the
audio signal sensing automatically switches ON again!
This technology is beneficial with many sources, especially with any kind of wireless sources
such as Airplay (WLAN) or Bluetooth audio systems: you can operate the wireless audio
source and the speaker system activates or deactivates according to the provided audio
signals.
To activate/deactivate the AUDIO SIGNAL SENSOR function, there is a switch on the back
named AUTO ON/STANDBY:
If the switch AUTO ON/STANDBY is in position OFF, the automatic function is deactivated
and the system can not power ON nor STANDBY automatically but you can operate it
completely manually.
In position ON, the system will wake up upon a recognized audio signal and - if there is no
more audio signal over certain time - it can automatically change into STANDBY.
• The TWO NEO/PRO Sound System offers a AUX AC OUTLET (0.2A) on the back, for supply of
a source device. With the audio signal sensing this enables very comfortable operation and
perfect integration of your TWO NEO/PRO speaker system with your wireless home
installations!
Audio Configurations
Connection to analogue audio sources with RCA- or phono connector outputs
To connect with conventional stereo use RCA-to-RCA or phono-to-phono audio cables and
connect it to the LINE 1 or LINE 2 inputs on the back of your TWO NEO/PRO.
The input sensitivity of the 3.5mm phono socket LINE 1 is prepared for portable devices like
smartphones, MP3-player etc.
The input sensitivity of the RCA input LINE 2 is prepared for high (standard) line levels, as
provided by stationary HiFi or PC.
If your audio source is mains powered, like streaming devices, you can connect it to the mains
socket on the back of your TWO NEO/PRO.
Connection to digital audio sources with S/P-DIF- or USB connectors
Digital optical socket (S/P-DIF TOSLINK): employ a standard optical cable and connect it to
the OPTICAL input on the back of your TWO NEO/PRO. Please remember to never bend the
optical cable in a small or sharp angle, to avoid damage of the optical fibre! The optical input of
TWO NEO/PRO supports digital PCM STEREO signals up to 24 Bit / 192 kHz.
USB socket: employ an USB cable or adaptor with USB-B plug to connect your USB audio
source to the USB socket on the back of your TWO NEO/PRO. The popular operating systems do
not require the installation of a driver. The USB input of TWO NEO/PRO supports digital PCM
STEREO signals up to 24 Bit / 96 kHz.
17