Wavemaster TWO NEO - Page 16

English
• The multifunction knob at the front of the right TWO NEO/PRO speaker box offers push and
turning function. This knob controls the basic functions of your TWO NEO/PRO :
1. ON and manually OFF: a short push powers ON the device, manually OFF can be
forced by a longer push (>2s) on the knob.
If manually set OFF a static red LED will confirm this.
In case of automatic standby, this will be visible through a slowly blinking red LED.
2. VOLUME control: if the device is ON, by turning the knob, the volume can be increased
or decreased.
After switching OFF and ON, the previous volume setting is recovered.
3. Sequencial input selection (short push on the knob when the device is ON):
Input Socket Indication Colour Signal Source, Format
LINE 1 Phono Socket
3.5mm stereo
green Smartphone, MP3-Player,
lower level, apprx. 500mV
LINE 2 RCA L, R white PC, stationary HiFi
standard level max. 2000mV
Bluetooth - blue Bluetooth Audio A2DP
Digital optical S/P-DIF TOSLINK orange PCM max. 24 Bit / 192 kHz
Digital USB USB-B purple PCM max 24 Bit / 96 kHz
• Before mains connections, check your mains power system to be appropriate to the
TWO NEO/PRO. The mains voltage (230V or 115V) of your power system you can set by the
VOLTAGE SELECTOR of your TWO NEO/PRO (beside the POWER switch) and you can verify
the actual setting of the mains voltage easily. Attention: if the mains voltage is set wrong, the
device may become defective! Always set the correct mains voltage to avoid defects!
• Connect the mains cable to the mains input socket and the wall socket plug connect to your
mains supply.
• Switch on the main switch on the back.
• ON/STANDBY, source selection as well as volume you can control with the multifunction
knob on the front of the right speaker box of your TWO NEO/PRO Sound System.
• The same and further settings like BASS, TREBLE, DEFEAT, LOUDNESS, and MUTING
can be controlled by the infrared (IR) remote control.
Note: If you emphasize the bass control too much, the maximum total volume will be limited
since the woofer may run at overstroke earlier. Please care not to overstroke the woofer too
much (audible distortions) since this can reduce the life-span of the woofers!
16