Waves SCHEPS 73 - Control Explanations

Waves Scheps 73
User Guide
6
2.2 Controls
Pre-Amp increases the harmonic distortion.
Range: -20 to10L (Line), -20 to -80M (Mic)
Default: 0 L
P
lease note:
• Two scales have been modeled - Line scale ranges from -20L to +10L and Mic scale from -20M
to -80M. Both scales switch in 5 dB increments. The Line scale will get extension of ‘L’ and the
M
ic scale ‘M’.
• In its default setting the Pre-Amp will not increase gain, just harmonic distortion. The distortion is
mild and adds some coloration.
Dri
ve activates Pre-Amp in drive state.
Range: On, Off
Default: Off
P
lease note:
• The Drive control turns the Scheps 73 into a distortion generator. This toggles the plug-in
to a
s
tate that emulates the insertion of a line level signal into the microphone preamp for distorti
on
effects. When Drive is turned on, the line selections on the Pre-amp are unavailable. When
turning on the drive control, the setting will automatically switch to Mic -20.
• A
ttention! - in Drive state the Pre-Amp will increase gain, and heavy distortion w
ill be
hear
d.
H
igh Gain sets the amount of high shelf (12 kHz) boost or cut.
Range: +/- 16 dB in 0.1 dB increments
Default: 0 dB
H
igh On/Off activates high shelf processing.
Range: On, Off
Default: On
M
id Frequency toggles between seven midrange frequencies.
Range: 360 Hz, 700 Hz, 1.6 kHz, 3.2 kHz, 4.8 kHz, 7.2 kHz, 10 kHz
Default: 1.6 k
Hz
M
id Gain sets the amount of midrange frequency boost or cut.
Range: +/- 18 dB in 0.1 dB increments
Default: 0 dB
Mi
d On/Off activates mid band processing.
Range: On, Off
Default: On