Waves SCHEPS 73 - Page 7

Waves Scheps 73
User Guide
7
Low Frequency toggles between four low frequencies.
Range: 35Hz, 60Hz, 110Hz, 220Hz
Default: 110 Hz
Low
Gain sets the amount of low frequency boost or cut.
Range: +/- 18 dB in 0.1 dB increments
Default: 0 dB
Low
On/Off activates low band processing.
Range: On, Off
Default: On
HP
Filter Frequency toggles between four high-pass filter frequencies (third order: -18dB per oct.).
Range: 50Hz, 80Hz, 160Hz, 300Hz
Default Setting: 50 Hz
HP Filt
er On/Off activates the high-pass filter.
Range: On, Off
Default: Off
N
ote: The high-pass band is the only one to have separate On/Off control for left and right, this is due
to the fact that it does not have a 0 position (Off).
Phase reverses the phase of the signal.
Range: On, Off
Default: Off
N
ote: The phase will be reversed after the EQ stage
E
Q In/Out activates the whole EQ processing.
Range: In, Out
Default: In
Monitor controls the source of the monitor output. (Stereo component only)
• Stereo (ST) and Duo modes:
o Left
(left side only)
o Mono (stereo signal summed to mono)
o Ster
eo
o Ri
ght (right side only)
• M
S mode:
o Mid (left plus right)
o Mono (stereo signal summed to mono)
o Ster
eo
o S
ides (left minus right)