Waves Scheps 73
User Guide
Default: Stereo
EQ Mo
de selects stereo processing mode. (Stereo component only)
There ar
e three EQ modes:
• Stereo - EQ controls and faders are in link mode. When setting a control on one side the other
side will change to the same value. Any difference in the settings between sides (that was
created using the Duo, and MS modes) will be preserved when moving back to Stereo mode.
• Duo - EQ controls and faders can be set independently in each channel.
• MS - this mode will apply an MS encoding matrix on the input of the plug-in. Allowing the user to
separately EQ and level the Mid (sum) and Sides (difference) signals. In this mode, an “M” (for
Mid) and “S” (for Sides) letters will be added at the header of the channels. M at the top of the
left side and S at the top of the right side.
In MS mode all the left side controls will affect the “Mid” signal in the matrix, while the right side
controls will affect the “Sides” signal in the matrix.
Defaul
t: Stereo
VU Meter displays the input or output level, depending on your selection.
Range: -20 VU – +3 VU
Meter
I/O provides the following metering modes:
• Input Metering shows the input level of the plug-in. The meter displays the post input fader
level prior to any other processing in the plug-in.
• Output Metering shows the output level of the plug-in. The meter displays the post
processing post output fader level in the plug-in.
Defaul
t: In
VU
Meter Headroom Calibration defaults to 18 dB headroom and can be adjusted using the little
screw at the bottom right side of each meter. Its value will provide an indication to 0VU.
Range: -12 - -24 dBFS
Defaults: 18 dBFS
Clip In
dicator indicates peak clipping and is located at the top right of the meter. It is almost invisible to
the eye until it is on.
Input adj
usts input level pre-processing
Range: +12 to -24 dB
Deafult: 0 dB
Out
put adjusts gain post plug-in processing
Range: +12 to -24 dB
Default: 0 dB
To Next Page
Loading...
Need help?
General