UART GPS NEO-6M User Manual Waveshare
www.waveshare.net
2. Right now, if the module is powered off, the setting of the baud rate will
be restored to 9600. To remain the settings, you should save the
configuration information into the memory, following the steps listed
below.
① Configure the baud rate, as the figure below shows.
② Unfold UBX->CFG(Config)->CFG(Configuration), and then select
2-I2CEEPROM in the Devices option. Click the button Send to save
the configuration. The figure below shows the steps in details.
To Next Page
Loading...
