Wavetronix Click 202 - Configuration

To Next Page

To Previous Page

CHAPTER 10  CLICK 112/114 111

Note

For speciﬁc information on how to use the Click 112/114 with the SmartSensor Matrix,

see the SmartSensor Matrix User Guide.

Conﬁguration

e Click 112/114 can be congured in three ways: DIP switches, the front panel menu, and

Click Supervisor.

ese three conguration methods can congure dierent sets of parameters; some of these

parameters can be set using multiple conguration methods, and some of them can only be

set using one particular method. Table 10.2 lists how each parameter may be accessed and

congured.

DIP Switch Front Panel Menu Click Supervisor

Baud Rate Yes Yes Yes

Channel Input Map Yes Yes Yes

Autobaud No Yes No

Reset to Default No Yes Yes

Description No No Yes

Location No No Yes

Device ID No No Yes

To use this

conﬁguration feature:

Hardware mode Software mode Software mode

Table 10.2 – Click 112/114 Conﬁguration Options

e nal row on the table refers to conguration modes. e DIP switches can be used to

choose between Hardware and Soware modes. If any of the switches are set to the ON

position, that particular parameter is set to Hardware mode and only the DIP switches can

be used to change its conguration options. If all switches are set to the OFF position for a

particular parameter, it is in Soware mode and the front panel menu and Click Supervisor

may be used to change conguration options. is will be discussed in greater detail in the

DIP Switches section of this chapter.

Note

Any setting which has been conﬁgured via the DIP switches will be read-only in Click

Supervisor and the front panel menu.

Other manuals for Wavetronix Click 202