Wavetronix Click 65 Series - Page 44

CHAPTER 4  WEB INTERFACE 43
Note
The selected baud rate for a port must match the baud rate used by the attached
sensor on that port. Otherwise, the Click 65x will not be able to communicate with
the sensor. In most cases, the default 9600 baud rate should be used for all Wavetro-
nix devices.
Set Date & Time
is section shows the current device date and time. If the Click 65x is connected to a trac
controller, it ought to automatically get the correct time from that device.
If the Click 65x isn’t getting the correct time from a trac controller, you can set the date
and time by clicking on the text eld toward the bottom of the box and using the calendar
that appears to select the desired date and/or time. en click Set. Be aware that in this
case, the date and time will only be valid until the Click 65x reboots. When it reboots, it will
revert to an invalid date and time and will need to set again.
Note
The Click 65x will not start collecting SPM data until it has a valid date and time.
Reboot Device
is button reboots the Click 65x without resetting the conguration.
Reset Device Configuration
Push Reset to clear the existing device conguration to factory defaults (excepting the net-
work settings, which will remain). is option cannot be undone, so use of this function
will require all sensor discovery, channel mappings, and other device elds to be recreated
aer reset.