wavin DRT-200 - 6.3 Pump control (speed control pump)

W
avin Tempower Control Manual
Wavin Tempower Control
Heating and Cooling systems
.
W
avin Tempower Control Manual
Wavin Tempower Control
Heating and Cooling systems
.
21
6
6
.
.
3
3
P
P
u
u
m
m
p
p
c
c
o
o
n
n
t
t
r
r
o
o
l
l
(
(
s
s
p
p
e
e
e
e
d
d
c
c
o
o
n
n
t
t
r
r
o
o
l
l
p
p
u
u
m
m
p
p
)
)
The WTC-3 will stop the system pump when there are no
r
equests from room thermostats. In this case, all actuators
a
re closed down and the pump will stop.
Output eight on the unit switches on if the output of at
l
east one control circuit switches on. The output may be
u
sed for the activation of the pump.
N
N
o
o
t
t
e
e
:
If analogue thermostats are connected to the base unit
then the out of use thermostat inputs must be connected
in parallel with the heating/cooling changeover input,
otherwise output eight will remain continuously switched
on in the cooling mode. This will keep the pump activated
during the cooling period.
N
N
o
o
t
t
e
e
:
this output is supply 230V