To Next PageTo Next Page
Need help?Do you have a question about the wavin WTC-3 and is the answer not in the manual?
General| Brand | wavin |
|---|---|
| Model | WTC-3 |
| Category | Control Systems |
| Language | English |
Document serves as planning assistance for specialist engineers.
Contains technical information about Wavin Heating and Cooling systems.
Installation by qualified engineer, observe standards and regulations.
System consists of base unit, thermostats, sensors, actuators.
Lists WTC-3 Base Unit, DRT-200, sensors, actuators.
Aesthetically pleasing digital room thermostat for maximum comfort.
Touch surface, digital construction, no moving parts, LED indicators.
Steps for setting mode and changing settings.
Turns heating/cooling off; actuator in closed position.
Adjusts temperature by touch buttons or finger movement.
Controls up to 7 thermostats and 21 actuators for heating/cooling systems.
Lists key features like thermostat control, humidity monitoring, programs.
Mounting the WTC-3 unit and connecting power supply.
Default settings for cooling/heating set points and changeover time.
Default settings for cooling/heating reference, economy set point, hysteresis.
Configuration for master thermostat selection.
Default settings for output enable/disable.
Default assignments for outputs to actuators.
Wiring and connection for analogue thermostats.
How the DRT-200's built-in sensor monitors humidity.
Connecting an override dew point sensor.
Regulating mixing valves for inlet water temperature control.
Configuration for 7 analogue thermostats, sensors, and mixing valve.
Configuration for 6 analogue thermostats, sensors, drying demand, and mixing valve.
Configuration for 7 DRT-200 thermostats, sensors, mixing, pump, dehumidifier.
Settings for configuration switches.
Settings for configuration switches.
Settings for configuration switches.
Communication interface, protocol, and parameters.
List of available MODBUS commands and their codes.
Pin configuration for RJ45 connector.
System requirements and licensing for the configuration program.
Instructions on how to install the configuration program.
Information on USB port usage and VCP drivers.
Steps to connect the WTC-3 to a laptop for configuration.
Details on connecting the USB and RS ports.
Setting the address for program and WTC-3.
Overview of major functions and data reading possibilities.
Technical specifications for the WTC-3 unit.
