Need help?Do you have a question about the wavin Sentio and is the answer not in the manual?
General| Housing Material | Plastic |
|---|---|
| Connectivity | Wi-Fi |
| User Interface | Touchscreen, Mobile App |
| Power Source | Mains |
| Mobile App Support | Yes |
| Power Supply | 230 V AC |
| Operating Temperature | 0°C to 40°C |
| Storage Temperature | -20°C to 60°C |
| Weight | 200 g |
Instructions for replacing batteries in the wall-mounted thermostat.
Instructions for replacing batteries in the handheld thermostat.
Download and install the Wavin Sentio app from Google Play or App Store.
Register your system using personal and device information.
Locate the Serial Number (SN) and Registration Key (RK) on the CCU sticker.
Press the learn button on the CCU to complete the connection.
Register wireless thermostats and sensors to the CCU.
Register wired thermostats and sensors to the CCU.
Access and navigate the system's profile selection menu.
Set up the hardware configuration for your system.
Select or modify the active system profile.
Details for Wired, Wireless, and Smart Radiator Thermostats.
Details for Wired, Wireless, Outdoor, and Floor Sensors.
Details for Central Control Units (CCU) and Extension Units (EU).
Details for Antennas, Actuators, and Commissioning Touch Screen.
Ports for temperature sensors, flow, return, and servo motors.
Ports for programmable I/O, ROXi bus, and analog/PWM signals.
Ports for voltage-free relays, pump relays, and 230V supply.
Ports for actuator outputs and internal unit connections.
LEDs indicating system status, power, and warnings.
LEDs for LAN status, updates, and peripheral enrollment.
LEDs for cooling, enrolling, channel selection, and modes.
Buttons for entering, selecting channels, and system reset.
Instructions for physically mounting CCU and Extension Units.
Wiring CCU, EU, and actuators correctly.
Procedure for attaching actuators to the manifold.
Guidelines for optimal placement of room thermostats and sensors.
Connecting to LAN and the commissioning touch screen.
Connecting smart thermostats and dehumidifier units.
Maximum component limits for the Sentio system design.
Selecting the correct system profile during initial setup.
Specific profile settings for heating/cooling sources.
Adjusting room regulation mode and servo types.
Registering global components like Extension Units and Outdoor Sensors.
Registering local components like thermostats and room sensors.
How actuators behave upon activation and system startup.
Controlling zones using the thermostat in each room.
Controlling zones remotely using the Sentio mobile application.
To Next Page
