WARNING: FAILURE TO FOLLOW THESE RULES
MAY RESULT IN SERIOUS PERSONAL INJURY
As with all machinery there are certain hazards involved with operation and use of the
machine. Using the machine with respect and caution will considerably lessen the
possibility of personal injury. However, if normal safety precautions are overlooked
or ignored, personal injury to the operator may result.
This machine was designed for certain applications only. We strongly recommend
that this machine NOT be modified and/or used for any application other than for
which it was designed. If you have any questions relative to its application DO NOT
use the machine until you contact with us and we have advised you.
Your machine might not come with a power socket or plug. Before using this
machine, please do ask your local dealer to install the socket or plug on the
Power cable end.
2.SAFETY RULES FOR ALL TOOLS
A. USER:
(1). WEAR PROPER APPAREL. No loose clothing, gloves, rings, bracelets, or
other jewelry to get caught in moving parts.
Non-slip footwear is recommended. Wear protective hair covering to contain long
hair.
(2). ALWAYS WEAR EYE PROTECTION. Refer to ANSLZ87.1 standard for
appropriate recommendations.
Also use face or dust mask if cutting operation is dusty.
(3). DON'T OVERREACH. Keep proper footing and balance at all times.
(4). NEVER STAND ON TOOL. Serious injury could occur if the tool is tipped or
if the cutting tool is accidentally contacted.
(5). NEVER LEAVE TOOL RUNNING UNATTENDED. TURN POWER OFF.
Don't leave tool until it comes to a complete stop.
(6). DRUGS, ALCOHOL, MEDICATION. Do not operate tool while under the
influence of drug, alcohol or any medication.
(7). MAKE SURE TOOL IS DISCONNECTED FROM POWER SUPPLY.
While motor is being mounted, connected or reconnected.
(8). ALWAYS keep hands and fingers away from the blade.
(9). STOP the machine before removing chips.
(10). SHUT- OFF power and clean the BAND SAW and work area before leaving
the machine.
3
To Next Page
Loading...