PowerFlight Battery
Troubleshooting
Possible Failures and Solutions
5. After Use
1.2m
Wide Open Water Operating
Range
Bluetooth SignalNo Obstacle in
the Water
Deep Water Area life jacket/helmet
4. Restrictions and Local Regulations
15 16
All rights reserved by WaydooAll rights reserved by Waydoo
1. Risk of fire, explosion and/or burns, including chemical burns.
2. Inspect battery for damage before charging and never charge a damaged battery.
3. Do not disassemble or modify the PowerFlight Battery for other purposes. Otherwise, the
warranty will be invalid.
4. Do not disassemble, puncture, impact, or drop the PowerFlight Battery.
5. Do not handle the PowerFlight Battery with wet hands.
6. Do not install or remove the PowerFlight Battery in water.
7. Do not discard the PowerFlight Battery randomly. Disposal of lithium–ion batteries requires
special handling and must be done in accordance with local laws and regulations.
8. Do not expose the PowerFlight Battery to direct sunlight, fire, or place it in an environment
where the temper ature exceeds 60° C (140° F).
9. ONLY Use the standard charger for charging.
10. Place the PowerFlight Battery in a safe place and avoid contact with young children or animals.
11. Check whether the PowerFlight Battery is normal before use. Using abnormal batteries may
cause damage, electric shock, fire, and even life-threatening situations.
12. If you need to store the PowerFlight Battery for more than one month, maintain the battery
It is prohibited to use this product in waters where there are swimmers or divers. It is forbidden
to operate in restricted traffic areas. Make sure to strictly abide by local laws and regulations.
Stay away from people, boats, floating objects, a large number of animals and plants, obstacles,
and hazardous waterswhen operating.
Refrain from flying in weather such as rain, thunder, snow, heavy fog, strong wind, and storms.
1. After use, press and hold the Power Button of the Controller Plus for 5 seconds, and power off
the Controller Plus.
2. Take the board out of the water. Short press the Power Button of the PowerFlight Battery and
then long press for 2 seconds. The PowerFlight Battery will beep to confirm it is powered off.
Unscrew the Rotary Locks and remove the PowerFlight Battery.
3. Unscrew the Front Wing and Stabilizer Wing fixing bolts and remove the wings.
4. Unscrew the L-shaped fixing bolts to uninstall the plus kit.
5. Rinse off the sand and dirt from the Board and other parts with fresh water.
If there are any problems during use, stop operating the product, lay on the board, and paddle with
your hands until you return to land. After the problem is solved, you can use the board again. If
there is any problem that cannot be solved, contact the after-sales service in time.
1. The battery fault light turns red: Check if the temperature of the battery is too high. If the
temperature is too high, stop using it and wait for the battery to cool down before continuing
use. Check whether the battery level is too low. If the battery is too low, charge immediately. If
the problem is still not solved, contact after-sales service in time.
2. The battery has no output: Check whether the plus power kit and the battery are properly
connected. If there is any looseness, tighten the L-shaped bolts in time. Normally, the battery
has output. The output indicator on the display will continue to light up in blue.
3. The battery cannot be charged normally: First, check whether the fault indicator of the
battery is on. If it is, contact the after-sales service to repair or replace the battery, Next, check
whether the charger indicator is flashing red. If the charger is in good condition, check
whether the AC plug of the charger and the DC battery port are properly connected. Tighten if
they are loose. If the connection is normal, turn the charger over. Make sure the rocker switch
of the electrical appliance is in the ON position and then the battery should be able to charge
normally.
4. The motor keeps making abnormal noises during use: Immediately release the trigger of the
remote control to stop the motor, turn off the remote control, lay on the board, and paddle
back to land using your hands. Take out the battery and check whether there is any foreign
matter in the propeller. If there is foreign matter, remove the propeller protective cover and
the propeller for cleaning. Before inspecting the propeller, make sure that the battery is
disconnected and remove the battery.
Explorer/Patroller PLUS Power Kit USER GUIDES Explorer/Patroller PLUS Power Kit USER GUIDES
To Next Page
Loading...
Need help?
General
