To Next PageTo Next Page
Need help?Do you have a question about the Wayne CWS Series and is the answer not in the manual?
General| Type | Water Softener |
|---|---|
| Minimum Water Pressure | 20 psi |
| Maximum Water Pressure | 125 psi |
| Minimum Water Temperature | 40 °F |
| Maximum Water Temperature | 120 °F |
| Inlet Connection Size | 1 inch |
| Outlet Connection Size | 1 inch |
| Drain Line Connection Size | 1/2 inch |
| Voltage | 120V |
| Inlet/Outlet Size | 1 inch |
| Maximum Clear Water Iron Removal | 10 ppm |
| Material | Polyethylene (tank), various (internal components) |
Details on the required electrical power input for the pump.
Specifications related to the pump's motor.
Available horsepower options for the pump models.
The acceptable range of liquid temperatures for pump operation.
Pressure settings for pump activation and deactivation.
Construction materials and components for the motor housing and seal plate.
Materials used for the pump's diffuser and impeller.
Details on the pump shaft material and piping connection sizes.
Instructions for unpacking the unit and checking for shipping damage.
Explanation of hazard classification signal words like Danger, Warning, Caution.
Essential safety rules for operating and maintaining the pump.
Information regarding potential chemical exposure and health risks.
Guidelines for safe electrical connections and grounding.
Safety advice for handling and operating the pump motor.
Precautions against shock, damage, and unsafe conditions.
Conditions and warnings related to pump installation location.
Description of different water sources like surface, ground, and storage.
Selecting an appropriate and safe location for pump installation.
Factors to consider when installing the pump in various well types.
Guidelines for selecting and installing inlet and outlet piping.
Information on pressure switch function and pipe sizing charts.
Specific steps for installing the pump in shallow well applications.
Procedures for drilled, driven, dug, cistern, lake, and spring wells.
Installation steps for drilled wells using a two-pipe jet system.
Installation steps for non-drilled wells using a two-pipe jet system.
Installation steps for drilled wells using a single-pipe packer.
Installation of deep well pump systems with storage tanks.
Procedure for converting a deep well pump for shallow well use.
Step-by-step guide to priming a shallow well pump.
Step-by-step guide to priming a deep well pump.
Procedures for draining the pump and conventional tanks.
Steps to follow after servicing or extended non-use of the pump.
Troubleshooting waterlogged tanks and pre-charged tank checks.
Information on pump bearing lubrication requirements.
Overview of the CWS repair kit and its components.
Detailed steps for disassembling the pump for repair.
Detailed steps for reassembling the pump after repair.
Information on available jet assemblies for different well types.
