To Next PageTo Next Page
Need help?Do you have a question about the Wayne SWS Series and is the answer not in the manual?
General| Maximum Suction Lift | 25 feet |
|---|---|
| Maximum Discharge Head | 150 ft |
| Voltage | 115/230V (Dual Voltage) |
| Flow Rate | 10 - 35 GPM |
| Power Supply | Electric |
| Material | Cast Iron |
Details on the required electrical power for the pump operation.
Information regarding the type of motor used in the pump system.
Specifies the horsepower ratings available for different pump models.
The pressure at which the pump automatically starts.
The pressure at which the pump automatically stops.
Material used for the pump's motor housing.
Material of the pump's seal plate.
Material of the pump's diffuser.
Material of the pump's impeller.
Material of the pump's shaft.
Specifies the size of the pump's suction connection.
Specifies the size of the pump's discharge connection.
Information regarding chemical exposure and health warnings related to California Proposition 65.
Key safety instructions for installation, operation, and maintenance of the pump.
Requirements and types of tanks for pump operation and water storage.
Guidance on selecting an appropriate installation location for the pump.
Considerations for installing the pump with different types of wells.
Instructions and recommendations for pump piping installation.
Step-by-step guide for priming the pump before initial operation.
Procedure for draining water from the pump for servicing or storage.
Instructions on how to drain water from conventional and precharged tanks.
Steps for restarting the pump after servicing or prolonged inactivity.
Troubleshooting and resolution for conventional tanks becoming waterlogged.
Troubleshooting and resolution for precharged tanks becoming waterlogged.
Information on pump bearing lubrication requirements.
Procedure for checking and adjusting precharge in storage tanks.
Step-by-step instructions for removing the old shaft seal.
Detailed guide for installing a new shaft seal assembly.
