QUICK START INSTRUCTIONS WAPC250
For parts, product & service information
visit www.waynepumps.com
Auto On-Off Water Removal
Pool Cover Pump
OPERATING INSTRUCTIONS & PARTS MANUAL
READ, UNDERSTAND AND FOLLOW ALL INSTRUCTIONS IN THIS MANUAL - DO NOT DISCARD.
Failure to follow these instructions could result in property damage, serious injury or death.
© 2017,
WAYNE/Scott Fetzer Company.
323903-001 1/17
(1) POOL COVER PUMP
(1) PUMP STRAINER
STEP 2 - INSTALL CHECK VALVE
STEP 3 - ATTACH STRAINER
STEP 4 - CONNECT GARDEN HOSE
STEP 5 - SECURE ROPE TO STRAINER
STEP 6 - POSITION ON POOL COVER
STEP 7 - PLUG INTO GFCI OUTLET
FOR FURTHER PLACEMENT TECHNIQUES AND
DETAILED INSTALLATION FOR INGROUND AND
ABOVE GROUND POOL APPLICATIONS, REFER
TO PAGE 3 - FIGURES (A-E).
(1) CHECK VALVE/HOSE
ADAPTER
(1) 25' ROPE
ROTATE PUMP
DOWN TO
LISTEN FOR PUMP
TO "CLICK" IN
FEED ROPE THROUGH
LOOP ON STRAINER AND
SECURE WITH KNOT
CLICK
INSTALL CHECK VALVE
SO ARROWS ARE
POINTING UPWARD
THE MOST COMMON CAUSE FOR THE PUMP
NOT REMOVING WATER CAN BE RESOLVED
BY FOLLOWING STEP 6 OF THE MAINTENANCE
SECTION. (PAGE 5)
STEP 1 - VERIFY PACKAGE CONTENTS
WAPC250G
ONLY
To Next Page
Need help?
General
