EN
136
means that this structure uses double
insulated or reinforced insulation for class
II products
means that the product must be used
indoors
means that the device must not be
disposed of with household waste
(2012/19/UE). It must be recycled.
Charger
Input voltage: 100-240 V
Output voltage: 42 V
G. Charging procedure
Please charge the battery of the scooter as follows:
• The battery can be recharged using a standard power outlet.
1. Insert the charger plug into the scooter battery (charging connector) by lifting the silicone cap that
covers the charging connector on the front right side of the footboard.
• Check that the charging connector is dry and plug the charger's power cable into a nearby mains
socket.
• When charging, the LED on the charger will turn red to indicate proper operation. When it turns green,
it means that the battery is charged.
• To complete charging, you must unplug the mains plug and then the plug connected to the battery.
Finally, close the battery socket cap.
• Unplug the mains plug
Lift the rubber ap.
Plug the power
adapter into the
charging port.
When charging is
complete, replace
the rubber ap.
To Next Page
Loading...
