2
2
WARNINGS
ANGEL™ 4
IMPORTANT SAFETY INSTRUCTIONS & GUIDELINES
WARNINGS FOR SAFE ANGEL™HANDLING
· The ANGEL™ is not a toy.
· Careless or improper use, including failure to follow instructions and
warnings within this Operator Manual and attached to the ANGEL™, could
cause death or serious injury.
· Do not remove or deface any warnings attached to the ANGEL™.
· Paintball industry standard eye/face/ear and head protection designed
specifically to stop paintballs and meeting ASTM standard F1776 (USA) or
CE standard (Europe) must be worn by user and any person within range.
· Must be at least 18 years of age to purchase the ANGEL™.
· Persons under 18 years of age must have adult supervision when using or
handling the ANGEL™.
· Observe all local and national laws, regulations and guidelines.
· Use only on professional paintball fields where codes of safety are strictly
enforced.
· Use compressed air/nitrogen gas only. Do not use CO2.
· Do not exceed 850 psi (58 bar) input pressure.
· Always follow instructions, warnings and guidelines given with any first stage
regulator you use with the ANGEL™.
· Use 0.68 calibre paintballs only.
· Keep the ANGEL™ switched off until ready to shoot.
· Treat every marker as if it is loaded.
· Never point the ANGEL™ at anything you do not intend to shoot.
· Do not shoot at persons at close range.
· Do not shoot at fragile objects such as windows.
· Always measure your markers velocity before playing paintball, using a
suitable chronograph.
· Never shoot at velocities in excess of 300 feet (91.44 meters) per second, or
at velocities greater than local or national laws allow.
· Do not fire the ANGEL™ with the breech open or without the bolt in the
breech, as high pressure gas will be emitted.
· Do not fire the ANGEL™ with the pull knob in the unlocked position.
· Never look into the barrel or breech area of the ANGEL™ whilst the marker
is switched on and able to fire.
· Never put your finger or any foreign objects into the paintball feed tube of the
ANGEL™
· Never allow pressurised gas to come into contact with any part of your body.
· Always switch off the ANGEL™ when not in use.
· Always fit a barrel blocking device to your ANGEL™ when not in use on the
field of play.
· Always remove all paintballs from the ANGEL™ when not in use on the field
of play.
· The Twisted Lock Gated Feed™ is designed to retain a number of paintballs in the
feed tube and breech area of the ANGEL™ Always ensure that these paintballs
are removed from the ANGEL™ when it is not in use on the field of play.
· Always remove the first stage regulator and relieve all residual gas pressure
from the ANGEL™ before disassembly.
· The ANGEL™ can hold a small residual charge of gas, typically 2 shots, with
the first stage regulator removed. Always discharge the marker in a safe
direction to relieve this residual gas pressure.
· Always remove first stage regulator and all residual gas pressure from the
ANGEL™ for transport and storage.
· Always follow warnings and guidelines given with your first stage regulator
for safe transport and storage.
· Only charge the ANGEL™ using the charger supplied.
· Only use 12 Volt negative earth vehicles as a power supply for the charger.
· Do not leave the ANGEL™ unattended whilst charging.
· Always store the ANGEL™ in a secure place.
· THIS OPERATOR MANUAL MUST ALWAYS ACCOMPANY THE PRODUCT
IN THE EVENT OF RESALE OR NEW OWNERSHIP.
· SHOULD YOU BE UNSURE AT ANY STAGE YOU MUST SEEK EXPERT
ADVICE.
WARNINGS
– IMPORTANT SAFETY INSTRUCTIONS & GUIDELINES
m
WARNING
ADHERE STRICTLY TO THESE AND ALL OTHER SAFETY INSTRUCTIONS AND GUIDELINES
To Next Page
Loading...
