Weatherfiuide" Deluxe Weather Forecaster with Barometer
Model 1735
Instruction Manual
Welcome to the Taylor® Weatherfiuide" System. Simple, reliable, accurate ... it allows you to monitor indoor or outdoor
locations from one room. The base unit reads indoor conditions, while the remote sensor wirelessly reports outdoor
weather conditions back to the base unit for an all-in-one weather display.
NOTE: Some units have a static cling label over the digital display. Please remove before use.
BATTERY INSTALLATION
The base unit operates on
2 AA
batteries (not included).
The remote sensor operates on
2
AA batteries (not included).
Do not mix old and new batteries. Do not mix alkaline, standard (carbon-zinc) or rechargeable
(ni-cad, ni-mh,
etc.)
batteries.
IMPORTANT:
Power the base unit first, and then the remote sensor, otherwise the units' transmissions may not properly
c nnect. Place the base unit as close as possible to the remote sensor during set up.
TIP:
When the temperature falls below freezing point, alkaline batteries used in outdoor units may freeze, lowering their
voltage supply and effective range. Use of Lithium batteries is recommended in extremely cold or hot locations.
Base Unit
The battery compartment is located on the back of the unit. Remove the battery compartment door. Install
(2)
AA size
batteries into the battery compartment according to the polarity markings. Replace the battery compartment door.
Rc
110te Sens r
The battery compartment is located on the back of the unit. Remove the battery compartment cover. Install (2)
AA
size
batteries into the battery compartment according to the polarity markings. Replace the battery compartment door.
After Powering Up the Units:
When the units are powered up, the LCD screens will light up for 3 seconds and the base unit will beep. The base unit will
begin to display indoor temperature and humidity. The outdoor temperature and humidity displays will show dashes
u(~.)n.
Allow at least 3 minutes for the base unit to connect with the remote sensor and analyze current outdoor temperature
conditions. A transmission signal icon
(''14'')
flashes next to the channel icon
("l1i,,)
on the base unit during this time. The
icon will dlsuppcar allor 3 minutes when analysis is complete. (Outdoor temperature and humidity readings may appear
while the icon is still Ilashing, as it takes the unit longer to analyze other forecasting conditions.)
II'
after 3 minutes the transmission signal icon
(''14'')
stops flashing and dashes remain, press and hold the "CH" button on
the back of the base unit for 2 seconds to send another signal to the remote sensor. Alternately, press and hold the "TX"
button in the remote sensor's battery compartment for 2 seconds to cause the sensor to search for the base unit again
during its next transmission. The transmission signal icon
("i4")
will flash as the base unit searches for the remote sensor's
sigllal.
POI'
best setup connection, keep the base unit and remote close to each other while trying to connect. Keep away
from athol' electronic equipment that may interfere with the connections, such as mobile phones, appliances, computers,
l'olhgcl'f1tol's, TVs, etc.
To Next Page
Need help?
General
