After cleaning windshield with alcohol wipe,
position the suction cup base in a preferred
location, hold in place and extend the arm by
loosening knobs C, D and E. The lever should be
in the release position.
Once extended, for extra tension and stability,
press down on the arm and then tighten Knob E
while pressing the suction cup base up against the
glass. Snap the lever into place and tighten knobs
C and D.
To adjust the width of the phone holder, use
Knob A.
To remove your phone, place thumb and forefinger
on either side of the Quick Lock & Release tabs
and press.
Ensure all knobs are secured prior to use.
Note: Please check state and local laws prior to use.
C
FE
D
LET’S TALK
800-441-6287 or 630-769-1500
For warranty information, please visit www.WeatherTech.com/warranty
Made in USA
© 2023 MacNeil IP LLC V2
67WF1
To Previous Page
Loading...
