Operation / Installation Manual – FCF 5,000, 9,000, 12,000, 16,000
Page 22
DEHUMIDIFY mode operation
● In DEHUMIDIFY mode, if the indoor temperature is higher than temperature setting, the unit will
operate in cooling mode and the fan will run on low speed
● Set temperature should be in range of 61°F 86°F or 16°C to 30°C
FAN mode operation procedure
● Temperature can not be set in this operation mode.
Battery Replacement in Wireless Remote Control
Wireless remote control battery requirements: Two AAA alkaline cells.
1. Slide the cell cover downward to take out the worn
cells. Replace the worn cells. (Note to the correct
polarity).
2. Close the cell cover.
3. The LCD will show all the functional figures and
letter codes after the batteries are installed. Wait
approximately 10 seconds for normal use.
4. The life span of batteries is approximately 1
year.(depending on usage)
5. If the wireless remote control will not be used for
an extended period of time, please remove the
batteries to prevent damage to the controller.
6. The operation of the controller should be within its
receivable range 33’ (10 meters)
7. If the controller doesn’t work after the batteries
have been replaced, remove the back cover and
press the “ACL” button to reset the controller.
To Next Page
Loading...
Need help?
General
