1
SmarTemp Control fx 2.0
a
Digital Timer Interface
a
Installation / Operation Instructions
a
General
Thank you for choosing Webasto to meet your heating needs. The Webasto SmarTemp Control fx 2.0 enables you to
preset start-up cycles of your Webasto heater 7 days a week with 4 individual times each day.
Operation
The Webasto SmarTemp Control fx 2.0 is controlled using a rotary dial around the outside of the unit to scroll
through menu options. Simply click the selection button ( ) to make your choice. The following sections will define
each menu item and its default setting.
Compatibility
All Coolant Heaters; the SmarTemp Control fx 2.0 has an output of 1A for the heaters ON/OFF signal. Heaters
requiring a higher amperage signal will require a relay to accommodate different specifications. See electrical
connections for details. Note: Relay not included.
Mounting Procedure
1. Find a suitable mounting location (on a flat surface if possible) in a visible area.
CAUTION: Always install in an area protected from the effects of weather
and contamination.
2. Use the drilling dimensions to lightly mark the two mounting holes.
3. (Optional Step) To route wire harness through the mounting surface,
drill a 17mm hole as notated on the drilling dimensions image.
NOTE: Always make sure there are no obstacles behind the mounting
location prior to drilling.
4. Secure the Webasto SmarTemp Control fx 2.0 using the two supplied #4
screws.
5. Apply the supplied “Heater Off” warning sticker in a highly visible
location to the driver’s area. Refer to the example sticker below.
6. Observe the Menu Descriptions section for proper menu setup.
To Next Page
Need help?
General
