ASSEMBLY
Remove the machine and contents from the carton. Be sure the carton is empty before discarding.
If you require any assistance with regards to the contents of the lawnmower contact us:
Tel: 01793 333212 - Mon – Fri 8.30am – 5.00pm (excl. Bank Holidays)
Email: customerservice@webblawnmowers.co.uk
FITTING GUARD/SHIELD
1. Install the safety cover on the sha with the safety cover bracket and fixing screws provided.
2. Tighten the screws aer seng the safety cover bracket at the appropriat
e posion.
FITTING NYLON LINE CUTTING HEAD
1. Align hole in adapter plate with hole in the sha and install Allen Key.
2. Thread cuer head onto sha (turning it an-clockwise) unl it is ght. Remove locking tool.
FITTING D-HANDLE
1. Place top handle onto drivesha.
2. Posion lower handle, beneath the top handle in a comfortable operang posion
3. Tighten the four fixing screws.
FITTING THE HARNESS
1. Place the clasp of the harness, through the Harness Eyelet located on the
drivesha
2. Adjust the Harness to ensure it is comfortable, but ght enough to allow you to operate the machine
appropriately.
INSTRUCTION MANUAL
OPERATION
DANGER
All model line trimmers & brushcuers can throw small stones, metal or small objects as well as material
being cut. Do not allow anyone to enter the operang DANGER ZONE with you. The danger zone is an area
15 metres in radius
Insist that persons in the RISK ZONE beyond the danger zone wear eye protection from thrown objects. If
the unit must be used where there are unprotected people, operate at a low throle speed to reduce the
risk of thrown objects.
DANGER ZONE
WITHIN 15 METRES - RISK ZONE GREATER THAN 15 METRES
GENERAL USE
WARNING
Prior to using the machine, ensure all hardware (bolts, screws & nuts) are securely ghtened.
Operate the trigger with your right hand & hold the D-Handle with your le hand.
The trigger increases and decreases the power of the engine to the aachment, increasing the
revoluon/reciprocaon of the aachment.
WORKING PLAN
Limit the amount of me the product is used connuously to a maximum of 40 minutes per session.
Leave the machine to rest between sessions for between 10-20 minutes.
Total amount of work performed per day with the machine, should be limited to 120 minutes maximum.
Connuous use of the machine can cause “Repeve Stress Injury (RSI)”. If you feel discomfort, redness or
swelling of your hands and fingers or any other body part, consult your doctor.
Check local regulaons for sound level and hours of operaon constraints.
Never transport the machine, whilst the engin
e is running.
To Next Page
Loading...