EasyManua.ls Logo

Webb WER40HPSFX - Maintenance, Cleaning & Storage; Routine Maintenance and Cleaning

Webb WER40HPSFX
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
- After hitting a foreign object, stop the engine and check thoroughly the mower in order to see if it
is damaged. Take the machine to a local Approved Service Dealer for inspection if necessary.
Repairs of this nature are not covered under the Manufacturers warranty.
- If the mower vibrates in an abnormal way, find the reasons why, and take your mower to a local
Approved Service Dealer.
WARNING
After the engine has stopped, the blade will still rotate a couple of seconds.
CAUTION
Operating on gradients could cause the machine to tip over.
Allowing anyone to operate this machine without proper instruction may result in injury.
Wear sturdy, full coverage footwear. Operating this machine with bare feet, or with open toe shoes or
sandals increases your risk of injury.
Do not use the machine at night or in poor light.
Be sure to transport the machine from one place to another with the engine off.
Be sure to wear heavy gloves when cleaning underside of the deck or handling the blade.
To prevent damage, check the machine for any signs of damage or other faults when operated.
MAINTENANCE, CLEANING & STORAGE
WARNING
Improper maintenance & storage of the machine may void your warranty. Keep the machine clean for better
and safer performance.
Turn off the engine before performing any maintenance. If the engine must be run, make sure the area is
well ventilated. The exhaust emits dangerous carbon monoxide gases.
MACHINE MAINTENANCE
Use only original equipment replacement parts. Other parts may not perform as well, may damage the unit
and may result in injury. In addition, use of other parts may invalidate your warranty.
Before each use, check all nuts & bolts to be sure they are sufficiently tightened.
We recommend only manufacturer original parts are used when maintaining this machine. Failure to do so
could invalidate your manufacturer’s warranty.
The engine must be switched off, with the spark plug cap removed, before the machine is unassembled,
cleaned, serviced or maintained.
ENGINE MAINTENANCE
REFER TO SEPARATE LONCIN ENGINE MANUAL FOR ENGINE MAINTENANCE.
CLEANING
CAUTION
Do not use a water hose or pressure washer to clean the engine. Water can damage the engine or
contaminate the fuel system.
MOWING INSTRUCTIONS
The lawn’s appearance will improve if it is always cut at the same height and cut in alternate directions as
shown below.
Under certain conditions, such as very tall grass, it may be necessary to raise the height of cut to reduce
pushing effort, prevent overloading of the motor and leaving clumps of grass clippings. It may also be
necessary to reduce ground speed and/or push the lawn mower over the area a second time. For extremely
heavy cutting, reduce the width of cut by overlapping the previously cut path and mow slowly. For cutting
convenience, it may be best to start mowing at a point close to the power supply and to work your way away
from the supply.
1. Walk, never run with the mower, be very careful when mowing uneven or rough ground.
2. Be careful when changing the direction of the mower on a slope. Mow across the face of slopes, never
down or up.
3. Do not mow excessively steep slopes.
4. Best results will be achieved if the grass is dry. Wet grass will clog the blade & grass collection system.
5. Grass grows at different rates at different times of the year. Never use the lowest cutting height for the
first cut of the season or in drought conditions.
6. Do not remove grass debris in the mower deck or on the blade by hand or with your feet. Instead use
suitable tools such as a brush or broom.
7. Check that all nuts, bolts and screws are well tightened.
8. Before mowing, place the grass collector in its position.
9. Before mowing make sure that the blade and the blade fixing screw are securely fastened. When blade
cutting edges require re-sharpening, this must be done evenly on both sides, to prevent any imbalance.
If you are unsure how to sharpen the blade, please visit your local Approved Service Dealer. If the blade
is damaged, it must be replaced.
10. When mowing, always wear a long trousers and strong footwear.
11. Do not run the engine in an enclosed and/or poorly ventilated area, where gas of the engine contains
carbon monoxide, which are dangerous for your health.
12. Work only when there is enough light.
13. Turn off the engine if you must leave the lawnmower unattended.
14. Never lift the rear of the mower while starting the engine and never place your hands and feet
underneath the deck or into the rear discharge chute while the engine is running.
15. Never change in any way the rated speed of the engine.
16. On self-propelled mowers, disconnect the self-propelled system before starting the engine.
17. Never lift or carry the mower while the engine is running.
18. Stop the engine and remove the spark plug cover in these cases:
- Before any operation under the deck or the rear discharge chute.
- Before any maintenance, repairing or checking operations.
- Before carrying, lifting or removing the mower.
- If you leave the mower unattended or changing the cutting height.
- To remove and emptying the grass catcher.
INSTRUCTION MANUAL

Related product manuals