7
Inspection
Joint cutters must be inspected in accordance with the corresponding conditions of use and operation
as needed; however, an inspection to ensure they are operationally safe must be performed by an
expert at least once a year. The results of the inspection must be recorded in writing and must be
stored at least until the next inspection.
Cleaning work
Prior to cleaning the joint cutter with a high-pressure cleaner, protect all accessible energized
switches, cable connections, etc. against water penetration by masking them o.
Cleaning tasks should only be executed in areas that are suitable and have been approved for this
purpose (oil separator amongst others).
Disposal
All operating uids and auxiliary materials must be disposed of in an environmentally-compatible
manner in accordance with country-specic regulations.
Important information for operating and maintenance personnel is marked by pictograms.
Warning against irritants or materials hazardous to health
Warning against a hazardous place
Warning against a suspended load
Wear ear protection
General regulation
Environmental protection
Hard hat
Safety shoes
Protective gloves
To Next Page
Loading...