9
Device description
The joint cutter of type SM 57-2 is used for cutting work on roads and buildings.
Drive
The joint cutter is propelled by an air-cooled Honda gasoline engine.
Force is transferred to the cutting shaft mechanically via a V-belt.
Operation
Start the Honda gasoline engine with the attached reversing starter. The engine speed is set directly
on the engine. The cutting depth is pre-set using the scale at the cutting depth adjustment. By
actuating the pedal the cutting disk is lowered to the cutting depth set.
The water supplied from the water tank mixes with the dust caused by cutting.
The manual guidance rod is used to steer the joint cutter.
To Next Page
Loading...