Weber 92-2001 User Manual

92-2001 • WATERCOLOR FIELD EASEL
ASSEMBLY/SET-UP INSTRUCTIONS
Martin/F. Weber Co.
4444 Lawton Avenue, Detroit, MI 48208 USA
Tel:(313)895-0700 • Fax:(313)895-0709
E-mail:Custservmud@aol.com
www.MartinUniversalDesign.com • www.weberart.com
STEP 1. Begin by removing easel from carton.
See Fig 1 below.
STEP 2. Unbuckle & Loosen leather strap, to release
legs of easel.
See Fig 2 below.
FIG. 2
FIG. 1
STEP 3. After unbuckling strap, spread-out legs of
easel and stand on their feet. See Fig 3 below.
FIG. 4
FIG. 3
STEP 4. Loosen wing-nut on each leg to allow for
height adjustment of legs. Tighten at desired height.
See Fig 4 below.
FIG. 5
STEP 5. Once all legs are extended and secure,
lower portion of easel should look similar to FIG. 5
FIG. 5

Weber 92-2001 Specifications

General

Brand	Weber
Model	92-2001
Category	Racks & Stands
Language	English

Summary

Watercolor Field Easel Assembly and Setup

Unpack Easel from Carton

Remove the watercolor field easel from its original carton.

Release Easel Legs Strap

Unbuckle and loosen the leather strap to release the easel legs.

Deploy and Stand Easel Legs

Spread out the easel legs and stand the unit upright on its feet.

Adjust Leg Height and Secure

Loosen wing-nuts on legs for height adjustment, then tighten to secure.

Secure Lower Easel Section

Ensure all legs are extended and secure, checking the lower easel part.

Adjust Canvas Support Holders

Loosen wing-nut, slide canvas holders to position, and retighten to secure.

Adjust Center Column Angle/Tilt

Use side lever to adjust center column angle or tilt, then re-tighten to secure.

Turn Center Column for Tilt

Loosen the easel lever to turn the center column support for desired tilt.

Use Adjustable Canvas Support

Use adjustable support for small or large canvases up to 33.5" H.

Enjoy Painting

Final step indicating completion of setup.