13
CHECK THAT THE BURNER VALVE IS OFF
Valve is shipped in the OFF position, but you should check to be sure that
it is turned OFF. Check by pushing down and turning clockwise. If it does
not turn, it is off. Proceed to the next step. If it does turn continue turning it
clockwise until it stops, then it is off. Proceed to the next step.
CONNECT GAS SUPPLY
a) To connect gas hose at the supply: Slide back the collar of the quick
disconnect. Push male fi tting of the hose into the quick disconnect, and
maintain pressure(1). Slide the collar closed(2). If it does not engage or lock,
repeat procedure.
b) To connect gas hose at the Fireplace: Slide back the collar of the
quick disconnect. Push male fi tting of the fi replace connection into the quick
disconnect, and maintain pressure(1). Slide the collar closed(2). If it does not
engage or lock, repeat procedure.
Gas will not fl ow unless the quick disconnect is properly engaged.
WARNING: Make sure that the gas supply hose is
positioned so as to avoid damage from foot traffi c or
other accidental damage.
(1)
(2)
a
b
(1)
(2)
DANGER
Do not use an open fl ame to check for gas leaks. Be
sure there are no sparks or open fl ames in the area
while you check for gas leaks. This will result in a fi re
or explosion which can cause serious bodily injury or
death and damage to property.
GAS INSTRUCTIONS
TOP VIEW
SIDE VIEW
To Next Page
Loading...
Need help?
General
