28iGRILL 3
|
USER GUIDE
Visit weber.com/igrillsupport to find out more about device compatibility,
languages supported by the WEBER iGRILL App, a full user guide with
instructional set up videos, and great barbecuing inspiration. Please read the
full user guide – especially the safety information – before using the WEBER
iGRILL 3 for the first time, and follow the instructions while using the device.
Intended Use
Use this device only for measuring and monitoring the temperature of grilled
items on WEBER iGRILL compatible products only. On the GENESIS II LX
models, the knob lights can be turned on and o directly from the WEBER iGRILL
App. Any use other than that which has been described may cause damage.
The manufacturer or retailer are not liable for damages arising from improper
use. When using an iGRILL 3, never leave your grill unattented and follow all
instructions in your grill owners guide.
Note: The device is not to be used by children or persons with reduced physical,
sensory or mental capabilities.
Note: Do not mix old and new batteries. Do not mix alkaline, standard or
rechargeable batteries.
Meat Probe Use
WARNING: Risk of injury! The probes are very sharp. Please be
careful when handling the probes.
WARNING: Risk of burns! Handling the temperature probes
without hand protection will result in severe burns. The coloured
probe indicators are not intended to be touched with bare hands
while using the barbecue as they are not heat-insulated. Please
wear heat-resistant gloves at all times while using this product in
order to avoid being burned.
Important Note: When using probes, be sure to route wire where it will not be
exposed to flames or temperatures exceeding 716°F (380°C). Avoid exposing
probes to temperatures below -22°F (-30°C). Temperatures below -22°F
(-30°C) or above 572°F (300°C) will not display in the app and will cause the
probe to disappear from connection.
Clean the probes before first use. The probes are not dishwasher safe. Donot
use chemicals or abrasive detergents to clean the probes. Wipe down the
probes with a damp towel or cleaning wipe. Take care not to expose the
probe’s wiring or the area where the wiring meets the probe to liquid .
The probes are not waterproof and damage may result from water exposure.
Never submerge the probes in water.
Important Information
To Next Page
Loading...
Need help?
General
