Weed Eater WE20HT - Troubleshooting and Technical Data; Troubleshooting Common Issues; Technical Specifications; Environmental Protection

TROUBLESHOOTING
a WARNING: Always stop the power tool and disconnect the power cord before performing any of the
recommended remedies below.
Trouble Cause Remedy
Hedge trimmer fails to operate
1. No power
2. Faulty wall outlet
3. Extension cord damaged
4. Circuit breaker shut off or faulty
1. Check power
2. Use another outlet
3. Check cord, replace
4. Reset or replace circuit breaker
Hedge trimmer operates
intermittently
1. Extension cord damaged
2. Loose internal connection
3. Internal wiring defective
4. Trigger defective
1. Check cord, replace
2. Call an authorized service center
3. Call an authorized service center
4. Call an authorized service center
Cutting blade stops under load Cutting too fast Cut at a slower pace.
Fails to stop when one switch lever
is released.
Internal wiring defective Call an authorized service center
Poor cut quality
1. Debris caught in blades
2. Damaged blades
1. Clear debris from blades
2. Call an authorized service center
TECHNICAL DATA
WE20HT
Rated voltage 120V~60Hz
Rated power 400 W
Cutting length 50 cm (19.7 in)
Maximum cutting diameter Ø17 mm (0.67 in)
Sound power level 96 dB(A)
Vibration level 30 m/s
2
Weight 3.27 kg (7.2 lb)
Protection class
/ II
Environmental protection
• Waste electrical products should not be disposed of with household waste.
• Please recycle where facilities exist.
• Check with your local authority or retailer for recycling advice.