1
1. NOTES
PLEASE READ THIS MANUAL BEFORE USING THE DEVICE, PAYING EXTRA
ATTENTION TO THESE SAFETY WARNINGS AND GUIDELINES. PLEASE KEEP THIS
MANUAL IN A SAFE PLACE FOR FUTURE REFERENCE.
1.1.Safety Warnings
Do not touch the nozzle or stepper motors, when the 3D printer is printing or just finished the
printing job, the nozzle temperature is up to 230°C.
Do not expose this device to water or moisture of any kind. Do not place drinks or other
containers with moisture on or near the device. If moisture does get in or on the device,
immediately unplug it from the power outlet and allow it to fully dry before reapplying power.
Do not touch the device, the power cord, or any other connected cables with wet hands.
Prior to operation, check the unit and power cord for physical damage. Do not use if physical
damage has occurred.
Before plugging the unit into a power outlet, ensure that the outlet provides the same type and
level of power required by the device.
Unplug this device from the power source when not in use.
Take care to prevent damage to the power cord. Do not allow it to become crimped, pinched,
walked on, or become tangled with other cords. Ensure that the power cord does not present a
tripping hazard.
Never unplug the unit by pulling on the power cord. Always grasp the connector head or
adapter body.
Ensure that the 3D printer is turned off and unplugged from its power source before making
repairs or performing service.
1.2.Filament
To use this 3D printer, please use the filament provided by our company. Filaments sold in the retail
market have different specifications and uneven quality, which can easily clog and damage the
nozzle and motor. If the 3D printer fails due to the use of third-party consumables, the warranty
will not be granted.
If the filaments are not used for a long time after unpacking, please seal them and preserve them.
PLA will absorb moisture when exposed to air for a long time, affecting the quality of printed
products.
To Next Page
Loading...