5. Cautions on Operation!!
[Note: In order to prevent product from damaging due to improper operation, please pay attention on following items.]
1、 The components of foot SPA chair may be damaged if it is over-loaded. So please note that the specifications
mentioned as below. Besides, it should be out of warranty if foot SPA chair is damaged due to over-loaded.
a) The Max. weight of the client sitting on the chair is 120KG.
b) Armrest should not be loaded over 30KG.
c) Foot SPA basin should not be loaded over 150KG.
2、 Take good care of the hand controller, do not sit on it or drop it down. Armrest shouldn’t go up when hand controller
is placed on it.
3、 Take good care of the upholstery of cushion.
a) Keep upholstery away from the sharp things, lighted ash of cigarette, or lighted match.
b) Keep upholstery away from direct sunlight, so as to avoid upholstery being discolored or aged.
4、 Do not repair foot SPA chair without authorization.
5、 Switches and buttons might be defective if you repeatedly switch on/ off in a short time.
6. If the performance of chair is defective or after you repair or replace a new circuit board, you can reinitialize the
electric circuit board as following. Press the buttons of and on the hand controller at the same time,
while power on. Release the buttons until four-wheeled massage hand work. Re-initialization is finished once
massage hand stop working.
7. It is normal phenomenon that chair might be sound during operation.
8. Switch off the power after each treatment. [The switch is at the right side of chair, 0 means off]
9. In order not to be shocked by electric or make electric board damaged, please do not open the hand controller and
control box without authorization.
10.Unplug the power cord before repair or clean the chair. Clean Chair with soft towel and some water. Please note that
organic and volatile solvent shouldn’t be used for cleaning.
11.If there is drain outlet on the ground for the basin, you could remove the rubber plug and put the pipe into the outlet
during foot SPA. If not, please keep plugging from water leaking. (See photo as below)