Weimer We-1400 - Radio Transmitter Maintenance; Replacing Batteries

Operang Manual Sesam 800 from Åkerströms
Replacing Baeries
If the indicaon LED on the transmier indicates low baery power, replace the baeries promptly. Be-
fore changing the baeries note that changing of baeries must take place in a clean environment free
from stac electricity.
The baeries are changed as follows:
1. Open the baery cover by unscrewing the 6 outer screws on the rear side of the transmier
housing.
2. Carefulle remove the cover by liing up the top of the baery cover.
3. Remove the used baeries and insert new baeries.
4. Close the cover by rst inserng the rear of the cover into the transmier and then push the top
back down.
5. Tighten the 6 screws (torque 1,0 Nm).
Fig 4