Weimer We-1400 - Activating and Deactivating Transmitter; Controlling the Winch; Pairing Transmitter and Receiver

Operang Manual Sesam 800 from Åkerströms
Operaon
Acvang the Transmier
The transmier is delivered with the baeries not installed. Insert the baeries according to chapter
”Replacing Baeries”.
Acvate the transmier by pushing the start buon ”ON” for 3 seconds. The transmier indicator will
ash GREEN quickly during startup and then ashing GREEN slowly when contact with the receiver is
enabled. The transmier is now enable to control the winch.
Deacvang the Transmier
To prevent unintended acvaon the transmier shall be turned o when not used.
Turn o the transmier by pushing buon ”OFF” for three seconds, the indicator ashes a couple of
quick RED to nish with a long RED. The transmier is now turned o. If you forget to turn o the trans-
mier it will shut itself o aer a me, idle-me (non-use).
Controlling the Device
The winch is controlled via the buons on the transmier.
The relaonship between buons and outputs are:
 Buon 1 Winch 1 ”IN”
 Buon 2 ”ON” funcon (3 sec.)
* Buon 3 Winch 1 ”OUT”
Learning of Transmier
If any part of the system has been replaced, the receiver and transmier will need to be paired
together.
 Dismount the cover of the receiver by remove the plasc caps to reach the screws.
 Press the buon ”ON” on the transmier unl the green indicator lights. The transmier is now
acve.
 Press the Learn/Erase buon on the receiver unl LED 7 is ON.
 The Learn Mode will be acve for 10 seconds (as long as LED 7 is ON).
 Press transmier buon 1 ”IN” to pair the transmier to the receiver.
 LED 7 blinks three mes if the learning has succeeded.
 Install the receiver cover and ghten the six screws to 2.0 Nm
 Mount the caps over the screws.