Installation and Operating Instructions
Remote controlled receiver for awning motors
With the Combio-868 MA, AC drives can be adapted for use with a
remote controlled motor.
Intended use
The Combio-868 MA may only be used for controlling roller blinds
and awnings. It is suitable for use with tubular motors.
When a command is transmitted, the receiver immediately goes
into self-latching mode.
Note:
Do not shorten or lengthen aerial.
1. Operate the drive as described in the motor’s instructions
(set end positions).
2. Run the hangings out to a central position with the fitting
wire.
3. Disconnect from the mains.
4. Disconnect the fitting wire.
5. Connect the Combio-868 MA to the motor.
34
WeiTronic Combio-868 MA
To Next Page
Loading...