Why does my Welbach ENTRIX 315 Welding System have no weld output and the high temperature light is on?
The high temperature light indicates that the Welbach Welding System has overheated. This can happen because the welder overheated, the duty cycle or amps are too high, or the airflow is blocked. To resolve this, allow the unit to cool with the fan on, reduce the duty cycle or amps, and clean the vents and fan with compressed air.
What to do if my Welbach ENTRIX 315 tool will not start?
If your Welbach Welding System tool won't start, it could be due to several reasons: there's no power at the outlet, the cord isn't connected, or the line voltage is incorrect. First, check the power at the outlet. Next, ensure the cord is properly plugged in. Finally, verify that the welder is plugged into a 230V electrical outlet.
Why does my Welbach ENTRIX 315 Welding System have erratic or improper arc or welding output?
An erratic or improper arc or welding output from your Welbach Welding System can be caused by bad weld connections, incorrect polarity, a painted or dirty workpiece, or a ceramic nozzle obstructed by welding spatter. To fix this, clean and tighten weld connections, connect the polarity correctly, thoroughly clean the workpiece, and clean or replace the nozzle.
What to do if my Welbach ENTRIX 315 has no weld output with ready light on?
If your Welbach Welding System shows no weld output but the ready light is on, it could be due to a loose weld cable or a poor connection between the work clamp and the workpiece. Ensure the weld cable connection at the welder is tightened. Also, make sure the area where the clamp is attached to the workpiece is clean, exposed metal, and free of dirt, paint, and oil.
Why does the main supply fuse shut off frequently on my Welbach ENTRIX 315 Welding System?
If the main supply fuse shuts off frequently on your Welbach Welding System, the circuit breaker rating might be too low. Install a circuit breaker rated for greater than 20 Amps.
How to fix a Welbach ENTRIX 315 when the fan is not operating?
If the fan in your Welbach Welding System is not operating, it may be blocked or dirty, or the fan may be broken. Remove any obstruction and clean the fan with compressed air. If that doesn't work, have the fan replaced by a qualified service technician.
Definitions of safety alert symbols (DANGER, WARNING, CAUTION, NOTICE) for hazard communication.
General safety precautions to reduce risk of personal injury and equipment damage.
General| Brand | Welbach |
|---|---|
| Model | ENTRIX 315 |
| Category | Welding System |
| Language | English |
To Next Page
