3
SETUP
1. Attach the video head to any 3.5V Welch Allyn rechargeable
battery handle.
DO NOT ATTACH TO A WALL TRANSFORMER.
2. With the power off, connect the video cable (supplied) to the
output on the back of the Video head.
3. Connect the other end of the video cable to the “Input” or “Video
In” on the video monitor, VCR, or other composite video input.
4. Attach the reusable speculum, provided with the system, to the
video head by rotating clockwise. The quality of the video image
will deteriorate if other speculum are used.
5. Turn on the power switch on the monitor
6. Turn the rheostat on the power handle to
FULL POWER
. For
optimum performance, the VideoPath Veterinary Imaging System
should always be used with the rheostat set on maximum
brightness. The electronic controls within the Video System will
automatically optimize the brightness of the image.
No further adjustments are necessary on the video head. The color and
brightness controls on the video monitor may need to be adjusted to
obtain the best possible picture quality.
To Next Page
Loading...