Maintenance and Storage
Rev 80002-20080228 9
Maintenance
The owner/operator is responsible for all
periodic maintenance.
WARNING
Never operate a damaged or defective welder.
WARNING
Improper maintenance will void your warranty.
Welder Maintenance
Make certain that the welder is kept clean
and stored properly. Only operate the unit in
a clean, dry operating environment. DO
NOT expose the unit to extreme conditions,
excessive dust, dirt, moisture or corrosive
vapors.
CAUTION
DO NOT use a garden hose to clean the welder.
Water will enter the welder through the cooling
slots and damage the electrical connections.
Use a soft bristle brush to remove dirt.
Use an air compressor (25 PSI) to clear dirt
and debris from the welder.
Inspect all air vents and cooling slots to
ensure that they are clean and unobstructed.
Every 3 months
Repair or replace cracked cables
Every 6 months
Vacuum or blow out inside. During heavy
service, clean out inside monthly
Storage
1. Allow the welder to cool completely
before storage.
2. Store in a clean, dry place out of direct
sunlight
To Next Page
Loading...