• Installation diagram in MMA mode
(AKA, Arc welding, Stick welding.) Switch over the front panel toggle to the MMA position. No gas is needed. Connect torch
to “plus” and ground to “minus” to run your MMA in “reverse polarity, electrode positive. DCEP
FLUX CORE WELDING .
Follow the above procedure, except shielding gas is not required nor does it have to be connected to your welder. Remember to
change the polarity on your welding lead so that the ground clamp is connected to the “plus” dinse connector on your welder
and the polarity lead which is located in the center, between the plus and minus dinse connectors, is connected to the “minus”
plug. DCEN
Work piece
Ground clamp
Power supply
Electrode holder
23
To Next Page
Loading...
