• Installation of regulator to gas tank •
If you choose to weld with C25 gas and solid core wire now will be the time to connect your regulator to your C25 welding gas
tank.
1. Thread the regulator on to the gas cylinder snugging it gently and remembering these are brass connectors.
2. Take the supplied hose connect one end of it to your gas regulator.
***Please note that the connection being made has
a "ball-and-socket" fitting that does not require
Teflon tape and should not be used. However, the
small double female brass fittings just above the
connection being made does not have a "ball and
socket" fitting on its upper half. Teflon tape can be
applied to the top half of that double female brass
fitting before connecting it to the regulator.
***Always use two wrenches when connecting
brass fittings together and do not over tighten.
28
3. Connect the other end to the connector in the back of your MIG welder snug it gently, there’s no need to over tighten.
***Using two wrenches to connect the gas hose to the back
of the welder.
To Next Page
Loading...
