Need help?Do you have a question about the Welger AP 42 and is the answer not in the manual?
General| Brand | Welger |
|---|---|
| Model | AP 42 |
| Category | Lawn and Garden Equipment |
| Language | English |
How to connect the baler to the tractor.
Adjusting the drawbar for different tractor hitch positions.
Connecting the PTO drive shaft to the tractor.
Maintaining the knotter mechanism for proper function.
Loading the twine spools into the baler.
Engaging the safety latch for the knotter trip mechanism.
Guiding the twine to the knotters.
Adjusting twine tension for proper knot formation.
Activating the knotter tripping mechanism.
Ensuring twine is correctly fed into the knotters.
Setting the bale counter to zero before use.
Adjusting bale density settings.
Setting the pick-up height relative to the ground.
Adjusting the windguard for different crop conditions.
Adjusting the mechanism that controls bale length.
Maintaining the correct PTO speed for operation.
Importance of proper windrow formation for efficiency.
Tips for achieving uniform bale formation.
Safety precautions when turning the baler.
Maintaining safety lighting and chocks.
Attaching a chute to direct bales left or right (Part 1115.81.91.01).
Information on optional special tyres for the baler.
Using wedges to increase bale density.
An optional drawbar eye for smaller tractors.
Using a cover sheet for short-stalk crops.
Benefits of a wide-angle PTO shaft for maneuverability.
Using a drive shaft with an overrunning clutch.
Attaching a trailer hitch for loading chutes or bale throwers.
Chute to direct bales for clearance (Part 1105.81.90.00).
Chute to load bales onto a trailer.
A loading chute that folds for transport.
Using an adjustable guide wheel for pick-up.
Information on the optional bale thrower attachment.
Procedure for changing the gear box oil.
Greasing the knotter unit components.
Cleaning and servicing gears.
Checking wheel nuts and tyre pressure.
Adjusting the ram guides for proper operation.
Adjusting the frame knife clearance.
Instructions for grinding baler knives.
Timing the needle movement relative to the ram.
Timing the feed mechanisms relative to the ram.
Adjusting packer position for bale shape.
Synchronizing cross feed and top feed.
Adjusting needle positions for timing.
Adjusting the tension of the knotter beak.
Safety clutch for AP 42/53 models.
Safety clutch for AP 38/48 models.
Safety clutch for the pick-up drive.
Mechanical safety for packer on AP 38/48.
Ensuring safe operation of the knotter tripping mechanism.
Function of the pick-up torsion spring.
Protection against needle overload.
Loading wire into the tying mechanism.
Threading the wire into the tying tiers.
Maintenance and lubrication for wire tying.
Safety mechanism for needles.
Adjusting the position of the needles.
Adjusting the shear lever for wire clamping.
Synchronizing the twister hook.
Timing needles relative to the ram for wire tying.
To Next Page