Need help?Do you have a question about the Well Vision and is the answer not in the manual?
General| Screen Size | 27 inches |
|---|---|
| Resolution | 1920 x 1080 (Full HD) |
| Panel Type | IPS |
| Refresh Rate | 75Hz |
| Response Time | 5ms |
| Aspect Ratio | 16:9 |
| Brightness | 250 cd/m² |
| Contrast Ratio | 1000:1 |
| Color Gamut | 72% NTSC |
| VESA Mount | 100 x 100 mm |
| Viewing Angle | 178° (H) / 178° (V) |
| Ports | HDMI, VGA |
Displays icons for high water temperature, low voltage, shift reminder, over speed, and fatigue.
Shows RPM, Voltage, driving distance, clock, water temperature, and fuel consumption.
Find the vehicle's OBD interface for connection.
Place the HUD on the dashboard for optimal viewing.
Conceal the OBD cable neatly along the dashboard seams.
Verify the HUD is connected to OBD2 and functioning correctly.
Use button presses to enter menus, adjust parameters, and save settings.
Long press setting button and plug in USB while HUD is off.
Adjust HUD speed value to match dashboard, range (50-150).
Adjust HUD RPM value to match dashboard, range (50-150).
Check connections, power, and test with another vehicle.
Verify vehicle compatibility (OBD2/EU-OBD) and settings.
Perform a factory reset (menu 13) to resolve issues.
Check speed unit (menu 9) and adjust speed offset (menu 0).
Calibrate RPM display by adjusting offset in menu 1.
To Next Page