www.Welltec.pro 16
Before using the heating function, swap the pipe installation frame and the outlet frame so
that the pipe installation frame is at the cold air outlet and the outlet frame is at the warm
air outlet. As marked on the control panel.
Swap the frames and install an air exhaust pipe.
The drainage pipe should be exposed to the outside of the room using a strip or window
seal. Using the control panel or the remote control, you can set the desired temperature
from 15 ℃ to 25 ℃.
When using the heating function, remove the rubber plug from the upper drain hole and
connect the drain pipe to it. Draining the condensate to the outside of the device will
increase the heating efficiency.
Warning. The heating mode works correctly in an ambient temperature between 7 ℃ and
23 ℃. While using the heating function, it is not possible to change the fan speed. It is set
to the highest level by default.
To Next Page
Loading...
