Step 2 – Check the Fuel Level
Before starting the engine, check to see that there is sufficient gasoline in the fuel tank. The fuel
gauge on top of the engine will indicate the fuel level in the tank. Add gasoline if necessary but
leave sufficient room in tank for expansion.
WARNING: This engine may emit highly
flammable and explosive gasoline vapors, which can
cause severe burns or even death if ignited. A nearby
open flame can lead to explosion even if not directly in contact with fuel.
• Do not operate near open flame.
• Do not smoke near engine.
• Always operate on a firm, level surface.
• Always turn engine off before refueling. Allow engine to cool for at least 2 minutes
before removing fuel cap. Loosen cap slowly to relieve pressure in tank.
• Do not overfill fuel tank. Gasoline may expand during operation. Do not fill to the
top of the tank. Allow for expansion.
• Always check for spilled fuel before operating. Clean up any spilled fuel before
starting.
• Empty fuel tank before storing or transporting the engine.
• Before transporting, turn fuel valve to off and disconnect spark plug wire.
IMPORTANT:
• Use only UNLEADED gasoline with an octane rating of 87 or higher.
• Do not use old gasoline.
• Never use an oil/gasoline mixture.
• Avoid letting dirt or water into the fuel tank.
STOPPING THE ENGINE
To stop the engine:
To stop the engine, release the brake handle.
WARNING: Allow the engine to cool for
several minutes before touching areas that
become hot during use.
CAUTION: Allowing gasoline to sit in the engine tank for
long periods of time without use can make it difficult to start the engine in the future. Never
store engine for extended periods of time with fuel in the tank.
11
To Next Page
Loading...
Need help?
General
