SPECIFIC RULES FOR YOUR JIG SAW
7
11. MAKING ADJUSTMENTS. Always turn off and unplug the jig saw before making adjustments or changing
attachments. Accidental start-ups may occur if the jig saw is plugged in during an accessory change. Do not touch the
attachment immediately after operation. Allow time for the attachment to cool and calm down before removing it.
12. TOOL MAINTENANCE. Develop a periodic maintenance schedule for your tool. Follow the instructions
for lubrication, storage changing accessories. Unplug the saw before making adjustments or changing accessories.
Before plugging the tool back in, check that the power switch is OFF.
13. CLEANING THE TOOL. When cleaning a tool be careful not to disassemble any portion of the tool. Internal
wires may be misplaced or pinched and safety guard return springs may be improperly mounted. Certain cleaning
agents such as gasoline, carbon tetrachloride, ammonia, etc. may damage plastic parts.
14. USE COMMON SENSE. These safety instructions can’t possibly warn of every scenario that may arise with this
tool, so always make sure to stay alert and use common sense during operation.
LASER SAFETY
ATTENTION: LASER RADIATION. CLASS 2 LASER. DO NOT STARE INTO THE BEAM
1. Do not look directly into the laser beam with unprotected eyes. Never look into the path of the beam.
2. Never point the laser beam towards reflecting surfaces. Never point the laser towards people or animals. Even a
laser beam with a low output can cause damage to the eyes.
3. Remove the laser batteries before storing the miter saw for an extended period of time.
4. Never open the laser module as unexpected exposure to the beam can occur. The laser cannot be replaced with
a different type of laser.
5. Repairs of the laser may only be carried out by the laser manufacturer or an authorised representative.
To Next Page
Loading...