11
ASSEMBLY & ADJUSTMENTS
FILLING THE OIL TANK
Your chain saw is shipped without oil inside. Before operating your pole saw, make sure to fill the oil tank with the
included oil. Use standard bar and chain oil for future lubrication. The use of the pole saw without enough saw chain
oil will damage the unit. Never operate the pole saw without saw chain oil.
Fig. 3
1
2
1. Disconnect the saw from the power supply.
2. Place the saw with the oil fill facing up. Clean the area around
the oil tank cap and then open it.
3. Fill the oil tank (Fig. 3 - 1) with standard bar and chain oil.
While doing so, make sure that no dirt or debris enters the oil
tank (since the oil tube could clog). Close the oil tank cap.
NOTE: Only use bar and chain oil. Other oils will run the risk
of damaging the unit and voiding the warranty. Take note of
temperature conditions. Using the saw at various temperatures
requires the use of different oils. Check the label on your bar
and chain oil to make sure that the temperature range is ap-
propriate.
4. Check the oil level every few minutes from the side oil gauge
window (Fig. 3 - 2) to ensure enough oil remains in the tank.
Refill oil before the level reaches the MIN line on the housing.
USING THE SHOULDER STRAP
1. Hook the shoulder strap onto the shoulder strap bracket
(Fig. 4 - 1). The metal plate of the shoulder strap should be
inserted into the slot (Fig. 4 - 2).
2. The shoulder strap helps to support the weight of the saw
during transportation and operation. Only put the shoulder
strap onto one shoulder so that you can move rapidly away
from the tool in case of danger.
WARNING! Never wear the belt diagonally across your
shoulders, as you won’t be able to quickly move away from
the tool.
3. The quick pull-off shoulder strap allows you to quickly re-
lease the shoulder strap by pulling on the red release strap
(Fig. 4 - 3). Practice using and releasing the shoulder strap
before sawing.
Fig. 4
1
2 3
Fig. 5
ADJUSTING THE TELESCOPING HANDLE
1. Flip up the telescope release lever (Fig. 5 - 1).
2. Extend the pole to the desired length and lock the telescope release lever to hold the extension pole in place.
NOTE: The pole is spring-loaded and will spring backwards to a shorter length if left unlocked.
1
To Next Page
Loading...
Need help?
General
