Make sure your extension cord is properly wired and in good condition. Always replace a damaged extension cord
or have it repaired by a qualified person before using it. Protect your extension cords from sharp objects, excessive
heat and damp/wet areas.
NOTE: See page 10 “Securing The Extension Cord” for properly attaching your extension cord to the tool.
WARNING: Electric shock may cause severe injury or even death. Do not expose to rain or use the tool
in damp locations.
Do not allow any part of the tool to make contact with water while it is in operation. If the appliance becomes wet
while turned off, wipe dry before starting. Do not touch the appliance or its plug with wet hands or while standing in
water. Wear rubber boots to reduce the risk of electric shock.
WARNING: The double insulated system is intended to protect the user from electric shock resulting
from a break in the tool’s internal insulation. Observe all normal safety precautions to avoid electrical
shock.
1. POLARIZED PLUGS. To reduce the risk of electric shock, this equipment has a polarized plug (one blade is
wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the exten-
sion cord, reverse the plug. If it still does not fit, use a correct polarized extension cord or contact a qualified electri-
cian to install the proper outlet. DO NOT modify the machine plug or the extension cord in any way.
2. GROUND FAULT CIRCUIT INTERRUPTER (GFCI) Protection should be provided on the circuit or outlet
used for this power tool. Receptacles with built-in GFCI protection are recommended to reduce the risk of electric
shock.
3. SERVICE AND REPAIR. To avoid danger, electrical appliances must only be repaired by qualified service
technician using original replacement parts; otherwise this may result in injury to the user or damage to the tool.
GUIDELINES AND RECOMMENDATIONS FOR EXTENSION CORDS
To prevent electric shock, Use only a UL-, CSA- or ETL-rated extension cord for outdoor, all-weather use.
When using an extension cord, be sure to use one heavy enough to carry the current your product will draw. An
undersized cord will cause a drop in line voltage resulting in loss of power and overheating. When in doubt, use a
heavier cord. The smaller the gauge number, the heavier the cord. The table below shows the correct size to be used
according to cord length and nameplate ampere rating.
FOR ALL DOUBLE-INSULATED TOOLS
Double insulation is a concept in electrical power tool safety, where two systems of insulation are pro-
vided. This eliminates the need for the usual three-wire grounded power cord. All exposed metal parts
are isolated from the internal metal motor components with protecting insulation. Double insulated
tools do not need to be grounded.
ELECTRICAL INFORMATION
AMPERAGE
REQUIRED GAUGE FOR EXTENSION CORDS
25 ft. 50 ft. 100 ft. 150 ft.
6 A 18 gauge 16 gauge 16 gauge 14 gauge
8
To Next Page
Loading...
Need help?
General
