Wen 4021 User Manual

9
ASSEMBLY AND ADJUSTMENTS
FILLING THE OIL TANK
1. Place the saw on a level surface. Clean the area around the oil tank cap and then open it.
2. Fill the oil tank (Fig. C - 1) with saw chain oil. In doing so, make sure that no dirt gets into the oil tank so that
the oil nozzle does not clog.
3. Close the oil tank cap.
2. Fasten the carabiner hook on the shaft bracket of
the shaft.
3. Always use the utility strap. Never carry the belt diagnolly across your shoulders and chest, but rather on one
shoulder so that you can move rapidly away from the tool in case of danger.
4. To release the strap, push both buttons and pull the lock apart.
INSTALLATION OF THE MIDDLE HANDLE BAR
1. Line the middle handle bar (Fig. D - 1) up so it is facing the same direction as the shoulder belt ring (Fig. D - 2)
2. Install the handle cover (Fig. D - 3) using the four included screws and hex nuts (Fig. D - 4) to secure the
handle.
Fig. C
1
Fig. D
1
2
3
4

Wen 4021 Specifications

General

Brand	Wen
Model	4021
Category	Pole Saw
Language	English